Post by Drayer on Apr 23, 2018 23:53:43 GMT -5
After unboxing (DO NOT PLUG IN YET) and checking screws and screen it's highly recommended to test your resin tanks prior to printing. The most common method below.
CHECKING THE TANK
1. Place a dry paper towel on dry surface.
2. Place tank on paper towel.
3. Slowly pour water into tank until 2/3 full.
4. Wait 30 minutes to an hour
5. Check tank to ensure is still 2/3 full
6. Check paper Towel to see that it is dry.
7. Slowly Lift Tank and check where it was to be dry as well
Should you find no leaks continue to set-up your printer. If you do find leaks, check the screws and re-test if tightening is needed. Otherwise DO NOT USE IT! Contact OGadget and/or order a new one.
PLUGGING IN THE PRINTER
1. Plug the power supply into the printer FIRST! It will spark if powered prior to doing so.
2. Plug the power supply into the wall outlet.
LEVELING THE BED
1. Remove packing foam from resin tank.
2. Loosen all four screws holding plate.
3. Lower the plate to bottom of tank using the knob (clockwise).
4. Once the plate touches the bottom tighten each screw while holding plate down. (this ensures it is touching on all four corners)
SET-UP SD CARD
see Setting up SD card
UPDATE FIRMWARE
1. Download firmware update 4/24/18 - V 1.5 Download Firmware
2. Extract contents to the SD card including Update.WOW
3. Power down printer
4. Insert SD card
5. Power the printer the on, the light will be purple while installing and turn green once done
6. Once light is green power down and remove card
7. Delete any update files
Your printer should be ready to go now!
EDIT(nosrev): Check out Thingiverse Post below. (Maybe this will be merged soon.)
Also see official Video by SparkMaker on how to print
Thingiverse Post
CHECKING THE TANK
1. Place a dry paper towel on dry surface.
2. Place tank on paper towel.
3. Slowly pour water into tank until 2/3 full.
4. Wait 30 minutes to an hour
5. Check tank to ensure is still 2/3 full
6. Check paper Towel to see that it is dry.
7. Slowly Lift Tank and check where it was to be dry as well
Should you find no leaks continue to set-up your printer. If you do find leaks, check the screws and re-test if tightening is needed. Otherwise DO NOT USE IT! Contact OGadget and/or order a new one.
PLUGGING IN THE PRINTER
1. Plug the power supply into the printer FIRST! It will spark if powered prior to doing so.
2. Plug the power supply into the wall outlet.
LEVELING THE BED
1. Remove packing foam from resin tank.
2. Loosen all four screws holding plate.
3. Lower the plate to bottom of tank using the knob (clockwise).
4. Once the plate touches the bottom tighten each screw while holding plate down. (this ensures it is touching on all four corners)
SET-UP SD CARD
see Setting up SD card
UPDATE FIRMWARE
1. Download firmware update 4/24/18 - V 1.5 Download Firmware
2. Extract contents to the SD card including Update.WOW
3. Power down printer
4. Insert SD card
5. Power the printer the on, the light will be purple while installing and turn green once done
6. Once light is green power down and remove card
7. Delete any update files
Your printer should be ready to go now!
EDIT(nosrev): Check out Thingiverse Post below. (Maybe this will be merged soon.)
Also see official Video by SparkMaker on how to print
Thingiverse Post