Post by Drayer on Apr 24, 2018 10:38:44 GMT -5
Post your resin type, manufacturer and cure time and other settings below! I'll compile this into a refined list later on.
-Resin: Micromake fragrance water washable (Transparent Yellow)
-Uv strength: 255
-Layer height: 0.025
-Base layer cure time: 40sec
-Other layer cure time: 5sec
-Z movement: 30up/100down
-Z lift: 5mm
This is one I found on the thingiverse.
EDIT(nosrev): Please use our Google Resin Form!
Hey Folks,
just modified the old SparkMaker Resin Form and added an additional option to select the SparkMaker (1.Gen and 2.Gen) Generation.
Hope this helps.
Cheers.
Google Form
Google Sheets (Result)
Thingiverse Post
-Resin: Micromake fragrance water washable (Transparent Yellow)
-Uv strength: 255
-Layer height: 0.025
-Base layer cure time: 40sec
-Other layer cure time: 5sec
-Z movement: 30up/100down
-Z lift: 5mm
This is one I found on the thingiverse.
EDIT(nosrev): Please use our Google Resin Form!
Hey Folks,
just modified the old SparkMaker Resin Form and added an additional option to select the SparkMaker (1.Gen and 2.Gen) Generation.
Hope this helps.
Cheers.
Google Form Google Sheets (Result) Thingiverse Post